No Products in the Cart
No excuses on this one. Nobody turned me. Nobody got into me. I did it to myself — and then I had to load it up and figure out what was left.
Hey guys, Chad here with Midlife Classic Cars.
So. I wrecked my Legend car.
Not "rubbed a fender" wrecked. Not "some kid got into me" wrecked. I mean I went to Dominion Raceway, got greedy with the throttle, and put the 63 car into the wall all by myself. No help from anybody.
Short version: the car is ugly, my pride is worse, and I'm already ordering parts.
Here's the long version.
This is the part where I have to tell on myself again.
I've been chasing the same problem all season. I can get the car into the corner just fine. It's getting it back out that keeps eating my lunch. The car doesn't want to rotate off the corner, so I keep leaning on it harder and harder trying to make it come around.
Well, at Dominion I finally leaned on it too hard.
Here's the thing about a Legend car. It's tiny, it's stiff, and it does not give you a lot of warning. One second you're fine. The next second the back end is coming around and you're just a passenger holding a steering wheel. There's no saving it at that point. You just brace up and wait for it to be over.
Nobody got hurt. That's the number one thing, and I want to say it early. These cars are built stout, the safety gear does its job, and I climbed out and walked back to the trailer under my own power. Mad, but walking.
The walk back is the worst part. It's not the hit. It's the walk.
Because now you've got to go look at it. And everybody in the pits is going to look at it with you. Racing is a small world and there is nowhere to hide a torn-up race car.
Sitting in the pits after. That's green tape holding my M logo on. Not exactly a factory repair.
Right front took the worst of it. Nose is pushed in, the fender is split, and the front bumper bar is bent back into the frame rails. The right side body panel is done. And yeah — that's masking tape on the fender holding my logo on for the ride home.
Funny thing. A couple posts back I wrote about seeing a team running plain masking tape for their car numbers, and how it took me back to when I first started racing. Well, the racing gods heard me. Now I'm the guy with tape on his car.
This is the question everybody in the comments is going to ask, so let me answer it straight.
No. It's fixable.
Here's how I got to that. With a Legend car, the body panels are honestly the cheap part of the conversation. They're fiberglass. They bolt on. Ugly panels look terrible in a video and cost you a lot less than you'd think.
What you actually care about is the tube chassis underneath. If the frame is tweaked, you are in a whole different world of money and time. So that's the first thing you check, and you check it before you get emotional about how bad the outside looks.
Mine came out on the good side of that list. Front end took the energy and did its job. The chassis looks straight to me. So this is a bodywork and front-end job, not a rebuild-the-whole-car job.
And honestly? I'd rather have a bent nose and a straight frame than a pretty car with a twisted chassis. One of those you fix on a weekend. The other one you fix with a checkbook.
Money is the obvious one. But the real cost is track time.
Every weekend the car is on jack stands is a weekend I'm not out there getting laps. And laps are the only thing that's going to fix my actual problem, which is the guy driving. I'm still learning. I need seat time more than I need anything else, and I just took a chunk of it away from myself.
That's the part that stings.
A few things I keep chewing on.
One. I was trying to fix a setup problem with my right foot. The car won't rotate off the corner, so I kept driving around the problem instead of fixing the problem. That never works. Sooner or later the car hands you the bill.
Two. I got impatient. I wanted the lap time right then instead of building up to it. In a Legend car, a tenth you take by force is a tenth that's going to come collect.
Three. Wrecking is part of it. I don't say that to let myself off the hook. But every single person I've talked to at the track who's any good has a wreck story, usually several. If you're not willing to tear something up now and then, you're going to run around at 80 percent forever and never learn where the edge actually is.
I found the edge. Then I found the wall right behind it.
Nope. Not even close.
Parts are ordered. I'm going to get the front end straight, get new panels hung, and get back out there. And when I do, I'm going to work on the setup instead of trying to muscle the car into doing something it doesn't want to do.
If you've raced Legends and you've got advice on getting one to rotate off the corner without it snapping around on you, please drop it in the comments. I mean it. I'm 46 years old racing against kids who've been doing this since they were nine. I will take help from anybody.
Three off our shelves that go straight at what I'm dealing with right now — prepping a race car, tuning it, and fixing the body when you bend it.
Carroll Smith's nuts-and-bolts guide to race car prep. If you work on your own car, this is the one people keep in the trailer. Inspection, fasteners, doing it right the first time.
This is the one for my exact problem. Why a car won't rotate, what to change, and how to stop fixing setup with your right foot. Same author, and it's the chassis-tuning bible.
Very fitting for me this month. Shaping, patching and fabricating panels yourself instead of paying somebody else every time you bend something up.
Thanks for hanging out, guys. If you've ever torn one up and had to go look at it in the pits, you know exactly how this week went. Like and subscribe over on YouTube so you can see the repair when I get into it. And sign up for the Midlife Classic Cars newsletter or look us up on social — just search Midlife Classic Cars. See you at the track. — Chad
Discover a treasure trove of rare and out-of-print car books, showcasing the history, design, and performance of classic automobiles.
Shop Now
